valve cap
英 [vælv kæp]
美 [vælv kæp]
阀门顶，阀盖
双语例句
- Oil valve stem, protective cap and valve-stem seal.
用机油润滑气门杆、保护帽和气门杆密封件。 - Because of their efficiency, wide operating range, ease of maintenance and cost factors, sieve and valve trays have replaced the once highly thought of bubble cap trays in many applications.
由于效率高、操作范围广、易于维护且成本低，筛板塔盘和浮阀塔板已经取代曾经广受欢迎的泡罩塔板，并且被应用在诸多行业中。 - It has a better reliability with the design improvement of signal tube site and structure, one way valve base, piston surface air chamber and tube connection cap.
采用改进的信号管位置结构、单向阀座、活塞端面气室与接管封帽等后，更有力地提高了产品的可靠性。 - When returning cylinders to the supplier, properly close the cylinder valve, replace and secure any valve outlet seals, and properly install the cylinder cap.
钢瓶返还给供应商时，正确关闭钢瓶阀门，替换并固定阀门排气口密封，正确安装钢瓶帽。 - Replace the cylinder outlet seal and valve cap.
替换钢瓶排气口密封和阀门帽。 - Check valve tags are typically mounted on the rim of the cap.
止回阀标签通常安置在阀帽的边缘上。 - Accumulator air-charging manifold Locate the Schrader air valve on the shock and remove the air valve cap.
蓄压器充气阀箱压缩空气瓶充气阀箱找到避震上的美嘴气阀，取下气阀帽。 - Leave the valve protection cap in place until the cylinder has been secured in place and is ready to be used.
让阀门保护帽一直留在原位，直到钢瓶已经固定好，并准备使用。 - Do not confuse with a commercially available valve cap!
不要与市场上买到的气门帽混淆！ - The valve protection cap should be left in place until the cylinder has been secured against a wall, a bench, or placed in a cylinder stand and is ready to be used.
在钢瓶靠着墙壁、工作台固定或放置在钢瓶座准备使用之前，阀门保护帽要一直留在原位。 - The self-locking type thread of the valve cap can ensure that an adjusting bolt can be automatically locked after the pressure is regulated each time.
阀盖的自锁式螺纹能保证在每次调压后，自动锁定调整螺栓。 - Bronze Valve Options and Accessories-Drain Cap, Oxygen Service, Stem Extensions.
青铜阀门选配件和附件-排泄塞，氧气应用，阀杆加长件。 - Only use the original valve cap!
只能使用原装气门帽！ - Doing so may damage the valve causing it to leak. Use a special cap wrench or adjustable strap-wrench to remove overly tight or rusted caps.
这样做可能损伤阀门，导致泄漏。使用专门的阀门帽扳手或活动扳手来卸开过紧或生锈的帽子。 - All parts inside adopt the stainless steel, and are installed on the valve cap, maintenance is convenient.
内部零件全部采用不锈钢制造，并且安装在阀盖上，维修保养极为方便。 - NEVER insert an object ( e.g., wrench, screwdriver, pry bar, etc.) into valve cap openings. Doing so may damage the valve causing it to leak.
禁止把物体（如扳手、螺丝起子、撬杆等）插入阀门帽的开口处。这样做可能损伤阀门，导致泄漏。 - The analysis and control of the casting crackle of valve cap
阀盖铸造裂纹分析及控制 - As for structure, a new cylinder supported bearing structure has been proposed, and a new kind of fixed valve plate which is fixed on the end cap of pump has been developed.
结构上，提出了新的缸内支撑轴承式结构，设计了一种固定安装于后端盖的固定式配流盘。